Search:
Photography Tips & Tricks




Instructions & Manuals




Square Perfect Info

Click to verify BBB accreditation and to see a BBB report.
 

Softbox Assembly Instructions

 Softbox Assemby -- 4 inch lamp ring connector Flex rod fit into corner pocket.
 1. The SP4" lamp ring connector is shown here with the large end of the flex rod inserted.  2. Small end of flex rod fits into corner pocket on the softbox tent.
 Fold 4 inch ring into the tent. Attach 4th rod into ring. 
 3. With three rods inserted into the ring and corners, fold the SP 4" ring into the tent.  4. Next insert the fourth rod into the SP 4" ring. Note: Keep the velcro flaps at the ring opening to allow sufficient slack.
 Insert 4th rod into pocket on velcro strap.  Push velcro strap into place.
 5. Insert the forth rod into the pocket on the velcro strap.  6. Push the velcro strap into place just below the lip of the  tent.
Note: The rods take a good deal of force to flex into position.
Close velcro straps.   Attach ring to Flash Unit.
 7. Now close the velcro flaps as shown in the picture.  8. The SP 4" ring can now be attached to the SP 160 flash unit.
DO NOT over tighten.
 Attach inner diffusion lens with velcro straps.  Attach outer diffusion lens to velcro patches on outer edges.
 9. Next attach the inner diffusion lens with the velcro straps.  10. Attach the outer diffusion lens to velcro patches on the outer edges.